DC Motor with Encoder

At $16.00 ready to be connected and run these motor offer a tremendous value for those interested in building little, very fast, responsive and sophisticated robots and those interested in developing controllers to run motors with encoders.

The overall dimensions of this motor and encoder combination are
1.25 inches high
1.00 inches wide
2.00 inches long
(About the same size overall as the "Tiny Motor" but with a bigger motor and higher voltage/power capability. Best motor for small, fast, intelligent robots.
The encoder signals on these motors are not buffered or squared up. Your electronics need to do that.

The motor is available with a 12 slot encoder or a 26 slot encoder. Same price.

Output shaft is 0.125 inches in diameter about 0.5 inches long. From the base to the center of the shaft is 0.625 inches.

Shipping and handling for all US destinations is $10.00 for all residential addresses.
Shipping and handling for all US destinations is $8.00 for all commercial addresses

Connector Kit CK-1

Provides two four pin encoder connector with pins and housings and a male/female power connector to simplify the connection of the motor to the controller and the motor power supply.

Price $4.00 ea.

Mailing Address                                Make Paypal Remittances to
H. S. Sandhu                                     harprit_sandhu@hotmail.com
Electric Vehicle Corporation
705 West Kirby Avenue                      Telephone
Champaign IL 61820-6833 USA          217-359-6751 (8am to 6 pm Central Daylight Time)